Burnham RTC (Return Temperature Control) Instrukcja Instalacji Pobierz pdf (Strona 2)

2 of 60

How To Use This Manual

User Interface

Testing the Control .........................................Pg 22

Troubleshooting .............................................Pg 22

Error Messages ...............................................Pg 23

Repair Parts ....................................................Pg 24

Appendix A: Mechanical And Electrical

Application Drawings ...............Pg 25

Appendix B: Boiler Circulator And Diverting

Valve Selection Charts .............Pg 46

Appendix C: Valve And Actuator

Mounting Instructions ..............Pg 58

Technical Data.................................................Pg 60

Limited Warranty ............................................Pg 60

User Interface ..................................................Pg 2

Display .............................................................Pg 3

Sequence of Operation ..................................Pg 3

Section A: General Operation ..............Pg 3

Section B: Control Operation ...............Pg 4

Section C: Control Settings ..................Pg 5

Section D: Temperature Monitoring ....Pg 6

Installation .......................................................Pg 7

Control Settings ..............................................Pg 20

View Menu ..............................................Pg 20

Adjust Menu ...........................................Pg 21

This manual is organized into four main sections. They are: 1) Sequence of Operation, 2) Installation, 3) Control Settings, and

4) Testing and Troubleshooting. The Sequence of Operation section has four sub-sections. We recommend reading Section A:

General Operation of the Sequence of Operation section, as this contains important information on the overall operation of the

control. Then read the sub sections that apply to your installation.

The Control Settings section of this manual describes the various items that are adjusted and displayed by the control. The control

functions of each adjustable item are described in the Sequence of Operation.

The control uses a Liquid Crystal Display (LCD) as the method of supplying information. The LCD is used in order to setup and monitor

the operation of the system. The control has three push buttons (Item, , ) for selecting and adjusting settings. As the control is

programmed, record the settings in the Adjust menu table, which is found in the second half of this manual.

Item

The abbreviated name of the selected item will be displayed in the item field of the

display. To view the next available item, press and release the Item button. Once the last

available item in a menu has been reached, pressing and releasing the Item button will

return the display to the first item in the selected menu.

Adjust

To make an adjustment to a setting in the control, press all 3 buttons for 1 second (the

Item,  and  buttons). The display will then show the word ADJUST in the top right

corner. Then select the desired item using the Item button. Finally, use the  and/or 

button to make the adjustment.

To exit the ADJUST menu, leave the adjustment buttons alone for 20 seconds.

When the Item button is pressed and held in the VIEW menu, the display scrolls through all the adjust items.

Additional information can be gained by observing the status field and pointers of the LCD. The status field will indicate which of

the control’s outputs are currently active. Most symbols in the status field are only visible when the VIEW menu is selected.

Item

Table of Contents

1 2 3 4 5 6 7 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag

Burnham RTC (Return Temperature Control) Instrukcja Instalacji Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Burnham RTC (Return Temperature Control)